HP XP P9500 Storage - Manual (Page 148)

This example shows how to enable the collection of audit log data:
# /usr/DynamicLinkManager/bin/dlnkmgr set -audlog on -audlv 6 -
category all
Specify on if you want to collect audit log data, and off if you do not want to
collect audit log data. If you specify on, you can use the -audlv parameter to
specify the collection level for audit log data and the -category parameter to
specify the audit log categories.
If you want to set the audit log facility, see Setting the Audit Log Facility on
page 3-82 .
Setting the Audit Log Facility
The following describes how to specify the output destination for audit log
data.
If you want to specify the output destination for audit log data, first specify
the audit log facility by using the dlnkmgr set -audfac command. Next,
define the output destination of the facility in the /etc/syslog.conf file. The
table below lists the values for the audit log facility setting. The default is
user.
Table 3-17 Values Indicating Audit Log Facility
Value Corresponding facility value in the /etc/syslog.conf file
user or 1 user
local0 or 16 local0
local1 or 17 local1
local2 or 18 local2
local3 or 19 local3
local4 or 20 local4
local5 or 21 local5
local6 or 22 local6
local7 or 23 local7
This example shows how to specify the audit log facility:
# /usr/DynamicLinkManager/bin/dlnkmgr set -audfac local0
Checking the Updated Settings
This chapter describes steps involved in how to check the updated settings by
using the dlnkmgr command's set operation after settings have been
changed.
3-82
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide for AIX ®