HP XP P9500 Storage - Manual (Page 108)

During installation, the KAPL09241-W message might be output. In this
case, installation of HDLM continues, but installation of HDLM components
has failed. After installing HDLM, resolve the problem according to the
KAPL09241-W message if necessary.
13
.
Execute the following command to make sure that the package is
installed.
# lslpp -la DLManager.mpio.rte
Make sure that the fileset item in the output listing contains
DLManager.mpio.rte, and all the displayed statuses are COMMITTED.
If one or more of the displayed statuses are BROKEN, remove and then re-
install HDLM.
14
.
Execute the following command to make sure that the hdisk.
# cfgmgr
15
.
Execute the following command and verify that the status of the hdisks is
Available:
# lsdev -Cc disk
hdisk0 Available 1S-08-00-8,0 16 Bit LVD SCSI Disk Drive
hdisk1 Available 1S-08-00-9,0 16 Bit LVD SCSI Disk Drive
hdisk2 Available 1S-08-00-10,0 16 Bit LVD SCSI Disk Drive
hdisk3 Available 1H-08-02 Hitachi Disk Array (Fibre)
hdisk4 Available 1H-08-02 Hitachi Disk Array (Fibre)
...
Make sure that all the displayed HDLM-related devices are Available.
hdisks 0 to 2 are the physical device file names of the host's internal
disks.
hdisk 3 and the following are the logical device file names that correspond
to physical volumes in the storage system.
16
.
Activate the volume group used by HDLM.
# varyonvg volume-group-name
17
.
Mount the file system used by HDLM.
# mount file-system-mount-point
18
.
Execute the dlnkmgr command's view operation to check the status of
each program:
# /usr/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(rr)
Support Cluster :
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(60)
3-42
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide for AIX ®