HP Surestore 2.28 Tape Library - Manual (Page 80)

4-36
Library Operation
Running an Internal Test
Running an Internal Test
CAUTION Some diagnostic tests, such as Exchange Demo, may place tape cartridges in
unexpected locations, which can cause problems with the software
application being used.
NOTE Some diagnostic tests can only be run through the SCSI interface. Refer to
Digital Linear Tape Drive and Library SCSI-2 Command Reference
(HP
part number 5960-7674) for information about these tests.
To run self-diagnostic tests:
1. Verify that the drive status displays (if not, press CANCEL until it does).
2. Press NEXT until ADMIN* appears in the display window, then press
ENTER .
3. Enter the three-part numerical password (see “Entering the
Administration Menu Password” on page 3-7).
4. INFO* displays. Press NEXT or PREV until TEST* displays, then press
ENTER .
5. Press NEXT until the name of the test to run displays, then press ENTER .
6. NUM LOOPS 1 displays, where the 1 is flashing. Press NEXT until the
number of test loops you wish to run displays, then press ENTER .
NOTE Press CANCEL at any time to abort a test. TEST CANCEL - WAIT displays
while the current test loop completes.
The following table describes the internal tests available from the control
panel. Tests are listed alphabetically according to function.