HP Surestore 2.28 Tape Library - Manual (Page 73)

4-29
Library Operation
Setting a Configuration Option
L
ib
r
ar
y
O
p
er
at
io
n
Setting a Configuration Option
1 2 3 4 ➔ ADMIN* ➔ PSWD 000-000-000 ➔ CONFIG*
Configuration options customize the way the library operates.
To change a configuration:
1. Verify that the drive status displays (if not, press CANCEL until it does).
2. Press NEXT until ADMIN* displays, then press ENTER .
3. Enter the three-part numerical password (see “Entering the
Administration Menu Password” on page 4-7).
4. INFO* displays. Press NEXT until CONFIG* displays, then press ENTER .
5. Press NEXT or PREV to display the desired configuration option, then press
ENTER . If the configuration has multiple settings, the current setting
flashes. Otherwise, the configuration option is set and OPTION SAVED
displays. (Configuration options are described in Table 4-8 on page 4-28.)
6. Press CANCEL to return to the drive status (“ready” state).
Table 4-8 Configuration Options
Config Name Description Default
RECOVERY
ON/OFF ON Library attempts to recover from errors.
OFF Library immediately stops moving if an error
condition occurs.
Default is RECOVERY ON, and recovery should remain ON
under normal conditions.
ON
RESTORE
DEFAULTS Sets all library configurations back to their default settings. —
CLEAR
ODOMETERS Used by service personnel only.
Sets all library odometers back to zero.
—