HP Surestore 2.28 Tape Library - Manual (Page 55)

4-11
Library Operation
Specifying SCSI Addresses
L
ib
r
ar
y
O
p
er
at
io
n
5. SET IDs* displays. Press ENTER .
LIB BUS0 ID # or DRV# BUS# ID # displays. (LIB BUS0 ID # stands
for the current SCSI ID of the robotics controller.
DRV# BUS# ID # is the current SCSI ID setting for the drive number and
its associated bus #.)
6. Press NEXT until the setting to change displays, then press ENTER .
7. The current SCSI address setting flashes. Press NEXT or PREV until the
desired address displays, then press ENTER .
8. Press NEXT until UPDATE IDs NOW displays, then press ENTER .
9. WAIT FOR UPDATE displays briefly, then IDs SAVED displays.
• If the new settings do not conflict with other SCSI IDs on the bus,
SCSI IDs* displays.
• If the new settings conflict with other IDs on the SCSI bus, CONFLICT
ABORTED displays briefly, then SET IDs* displays. Any changes
entered are lost, and previous steps must be repeated to set a new
address.
• If any buses are daisy chained together, make sure the SCSI IDs are
different for each device on the bus.
• If a serial communications error is detected while trying to set the
SCSI IDs,
DRV CONNECT ERR displays, followed by IDs NOT
CHANGED . Any changes entered are lost. The SCSI IDs* menu
displays.
10. Press CANCEL three times to return to the drive status (“ready” state).
11. New settings can be saved to flash ROM. Turn the library off, then turn it
back on. This allows the settings to be recovered if the library is powered
off for more than ten days.
NOTE After you change an address, it may be necessary to reboot the host. This
allows the new SCSI IDs to be recognized.