HP Surestore 2.28 Tape Library - Manual (Page 54)

4-10
Library Operation
Specifying SCSI Addresses
Viewing the Current SCSI Address Settings
1 2 3 4 ➔ ADMIN* ➔ PSWD 000-000-000 ➔ SCSI IDs* ➔ VIEW IDs*
To view the current SCSI address settings:
1. Verify that the drive status displays (if not, press CANCEL until it does).
2. Press NEXT until ADMIN* displays, then press ENTER .
3. Enter the three-part numerical password (see “Entering the
Administration Menu Password” on page 4-7).
4. Press NEXT until SCSI IDs* displays, then press ENTER .
5. SET IDs* displays. Press NEXT until VIEW IDs* displays, then press
ENTER .
6. BUS0 LIB ID# or BUS# DRV * ID * displays. (BUS0 LIB ID # stands
for the current SCSI ID of the robotics controller.
BUS# DRV # ID # is the current SCSI ID setting for the displayed drive
number and its associated BUS#.)
Press NEXT or PREV to scroll through the current address settings.
7. Press CANCEL until the next operation to perform displays, or until the
drive status (library “ready” state) displays.
Setting the SCSI Addresses
1 2 3 4 ➔ ADMIN* ➔ PSWD 000-000-000 ➔ SCSI IDs* ➔ SET IDs*
A SCSI address is required for the robotics controller and each tape drive.
For more information, see Table 4-2, “Default SCSI Address Settings” on page
4-9, and the section “Viewing the Current SCSI Address Settings” on page
4-10.
To change the current SCSI address settings:
1. Verify that the drive status displays (if not, press CANCEL until it does).
2. Press NEXT until ADMIN* displays, then press ENTER .
3. Enter the three-part numerical password (see “Entering the
Administration Menu Password” on page 4-7).
4. Press NEXT until SCSI IDs* displays, then press ENTER .