HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 52)

Domain management 52
The VC-FC SNMP settings apply to all VC-FC modules in the VC domain.
The following table describes the fields within the SNMP Configuration screen.
Field name Description
Enable SNMP Select to enable SNMP
Enable SMI-S Select to enable SMI-S. Only available for HP 4Gb VC-FC Modules.
System Contact Specify contact name for this system when SNMP is enabled. The maximum
length is 12 characters.
Read Community Controls SNMP read access when SNMP is enabled. The default value for the
read community string is "public". The read community string must always be
set when SNMP is enabled. The maximum length is 12 characters.
SNMP Trap Destinations SNMP trap destination table. The maximum number of trap destinations allowed
is five.
Destination User-designated name for the trap destination
IP Address IPv4 address or DNS name for the trap destination. DNS names are not
allowed for FC traps.
Community String The Community String acts like a password for a given trap destination. The
trap-receiving application can use the community string to filter the incoming
traps.
Default: public
Format Format of the new trap. SNMPv2 traps are not supported on VC-FC modules.