HP Designjet T1300 ePrinter - Manual (Page 206)

Table 20-2 Numerical error codes (continued)
Error code Recommendation
61:08.1 Resend the job without password protection.
62, 62:04, 63 Update your printer's firmware. See Update the firmware on page 138 .
63:01 The printer has failed to get an IP address. Connect to another network or change the IPv4
configuration.
63:04, 64 Update your printer's firmware. See Update the firmware on page 138 .
64.1:01 The external hard disk has been removed while it was in use. Please reconnect it and restart
the printer.
64:04, 65, 65:04 Update your printer's firmware. See Update the firmware on page 138 .
66:08 The job cannot be printed on the paper type that is loaded.
67, 67:04 Update your printer's firmware. See Update the firmware on page 138 .
68:03 Restart the printer.
71.04 Out of memory. To avoid this, in the HP-GL/2 and HP RTL driver select the Advanced tab
and then Send job as a bitmap.
71:03 Restart the printer.
71:04 Update your printer's firmware. See Update the firmware on page 138 .
74:04, 74.1:04 The firmware upgrade has failed. Press OK and try again. See Update the firmware
on page 138 .
74.1 Try the firmware update again. Do not try to use your computer while the update is in
progress.
74.8:04 The firmware upgrade has failed. Your firmware file may be incorrect; try to download it
again. See
Update the firmware on page 138 .
76:03 Restart the printer.
77:04, 78.1:04 Update your printer's firmware. See Update the firmware on page 138 .
78:08 Borderless printing not possible; setting ignored..
79:03 Restart the printer.
79:04, 79.1:04 Update your printer's firmware. See Update the firmware on page 138 .
81:01 Please follow the instructions on the front panel. You may be asked to run a test procedure and
write down a numeric code before contacting HP Support. See
Contact HP Support
on page 203 .
81:03, 84:03 Restart the printer.
86:01 Please follow the instructions on the front panel. You may be asked to run a test procedure and
write down a numeric code before contacting HP Support. See
Contact HP Support
on page 203 .
94, 94.1, 94:08 Restart color calibration. See Color calibration on page 86 .
94:02 Color calibration failed. Check that the paper type that is loaded corresponds to the paper
type that you have selected.
198 Chapter 20 Front-panel error messages ENWW