HP Designjet T1300 ePrinter - Manual (Page 168)

9. Close the window.
10. Switch on the printer.
11. Reload the roll, or load a new sheet see Paper handling on page 38 .
NOTE: If you find that there is still some paper causing an obstruction within the printer, restart the
procedure and carefully remove all pieces of paper.
A strip stays on the output tray and generates jams
If a small piece of paper (200 mm or smaller) has been cut, such as before (if new roll) and after a full-
bleed print or after the front panel option Form feed and cut has been used, the cut strip remains in
the output tray. Only when the printer is not printing, reach into the tray and remove the strip.
160 Chapter 16 Troubleshooting paper issues ENWW