HP Designjet T1300 ePrinter - Manual (Page 169)

The printer displays out of paper when paper is
available
If the roll has become loose from its core, it will not feed correctly and the printer will not load the
paper. If possible, tighten the paper to its core or load a new roll.
Prints do not fall neatly into the basket
● Ensure the basket is correctly installed.
● Ensure the basket is open.
● Ensure the basket not full.
● Paper often tends to curl near the end of a roll, which can cause output problems. Load a new roll,
or remove prints manually as they are completed.
The sheet stays in the printer when the print has
been completed
The printer holds the paper to allow the print to dry after printing, see Change the drying time
on page 48 . If the paper is only partially ejected after the drying time, gently pull the sheet out of the
printer. If the automatic cutter is disabled, use the Form feed and cut option in the front panel, see
Feed and cut the paper on page 49 .
The paper is cut when the print has been completed
By default the printer cuts the paper after the drying time has been completed, see Change the drying
time on page 48 . You can disable the cutter, see Turn the automatic cutter on and off on page 48 .
The cutter does not cut well
By default the printer is set to automatically cut the paper after the drying time has been completed.
If the cutter is turned on but not cutting correctly, check that the cutter rail is clean and clear of any
obstacles.
The roll is loose on the spindle
The roll may need to be replaced or reloaded.
Recalibrate the paper advance
Accurate paper advance is important to image quality because it is part of controlling the proper
placement of dots on the paper. If the paper is not advanced the proper distance between printhead
passes, light or dark bands appear in the print and image grain may increase.
ENWW The printer displays out of paper when paper is available 161