HP Designjet T1300 ePrinter - Manual (Page 157)

5220-22.m requirements for clearing and sanitization of disk media. This is the default
security level when using Secure Disk Erase. If you choose this level, the process can take up
to six hours.
9. The front panel displays Press OK to continue with the external hard disk installation
or Cancel to abort. The printer will restart during the process.
10. Press OK.
11. The front panel displays External hard disk installation in progress. Please do not
remove the USB disk. This process will take a few minutes and will reboot the
printer.
12. The printer restarts.
13. The front panel displays a message in English, but you should wait until it displays Ready.
If you connected the USB cable to the printer without using the front panel first, please follow these
steps:
1. The front panel displays External hard disk detected. Press OK to continue with
External Hard Disk Installation or Cancel to abort.
2. Press OK.
3. Go to step 7 above.
Uninstallation
1. Ensure that the printer is turned on.
2.
At the front panel, press , then , then Setup > External hard disk > Uninstall
external hard disk.
3. Choose the Secure Disk Erase (SDE) level for the external hard disk.
4. The front panel displays External hard disk: Press OK to continue with External Hard
Disk uninstallation or Cancel to abort. The printer will restart.
5. Press OK.
6. The front panel displays External hard disk: Remove External Hard Disk.
7. Remove the external hard disk.
8. The printer restarts.
Troubleshooting
● The use of the external hard disk by any device other than an HP Designjet is not supported and
may cause severe damage to the hard disk, which is not covered by the warranty.
● If the external hard disk has been previously inserted into a different HP Designjet, the front panel
displays: External hard disk not valid for this machine. Power off, plug in the
correct hard disk and power on again.
ENWW Introduction to the accessories 149