HP Modular Cooling System - Manual (Page 48)

Frequently asked questions 48
Frequently asked questions
Frequently asked questions
Question Answer
How many user sessions are
supported at one time?
Only one user session is supported at a time. Sessions can be
terminated if a second session is initiated or if a console session
timeout occurs.
How many Admin sessions are
supported at one time?
Only one Admin session is supported at a time. Sessions can be
terminated if a second session is initiated or if a console session
time-out occurs.
Why does my Admin session keep
getting disconnected? If a second Admin session is initiated, the existing session is
terminated and the login screen appears.
Why can I not login using my FTP user
name and password? FTP Admin and Users are blocked until the Admin assigns passwords
and FTP is enabled in the Management menu of the Remote Access
tab.
How do I upgrade my firmware?
For more information, see the Support Pack instructions included with
the firmware upgrade.
How do I change the management
module IP address?
You can change the management module through the Network menu
(on page 30 ) or through the serial interface. For more information on
changing the management module IP address through the serial
interface, see the HP Modular Cooling System User Guide on the
documentation CD included with is kit.
Why do I get an extra line feed sent
from Windows® when I access the
serial interface connected through a
HP 16- and 48-Port Serial Console
Server?
You must assign this command to the HP 16- and 48-Port Serial
Console Server, where port X is the port where the MCS unit is
connected.
port x set out If=strip
port x set flow=Xonxof
Why are FTP admin and user logins
not recorded in the FTP.log?
Only FTP file uploads are recorded in the FTP.log.
Can I assign the SSL default port 443
as a non-SSL port? Yes, you can configure any port, including port 443.
Why is the configuration file, when
restored, not appearing in the FTP
upload directory?
The configuration file is restored in another directory.
Why are active alarms appearing
after I power-cycle my management
module?
The alarms are updated every 30 minutes. If you power-cycle the
management module in-between this time frame, the alarms are still
active and appear. After power-cycling the first time, clear the
alarms, wait 30 minutes, and power-cycle again.
Why are my event.log and alarm.logs
not formatted correctly when I
download them in .bin mode?
The event.log and alarm.log are not formatted to be downloaded in
.bin mode. Use ASCII mode.