HP Modular Cooling System User Manual
Page 29
Web interface 29
To change the general parameters:
1.
Enter a date in the Date field. (If NTP is enabled in the Network menu, do not enter a date in this field.)
2.
Enter a time in the Time field. (If NTP is enabled in the Network menu, do not enter a date in this field.)
3.
Select a date format from the Date Format dropdown box. Use MM/DD/YYYY for U.S. date format and
DD.MM.YYYY for Euro/World format.
4.
Select a temperature unit from the Temperature Units dropdown box.
5.
Select a measurement unit from the Measurement Units dropdown box.
6.
Select to enable or disable the audible alarm from the Audible Alarm (Beeper) radio buttons.
o
Select Enable to allow the audible alarm to sound when an alarm is generated.
o
Select Disable to not allow the audible alarm to sound when an alarm is generated.
7.
Select to enable or disable the reset alarm relay function in the Alarms/Warnings tab (on page
),
using the Alarm Relay Options radio buttons.
o
Select Enable to allow the alarm relay function when an alarm is generated.
o
Select Disable to not allow the alarm relay function when an alarm is generated.
8.
Select to close, open, or turn off the alarm relay options from the Alarm Relay Options radio buttons.
o
Select Close so that the alarm relay disconnects a circuit (normally closed) upon alarm activation.
o
Select Open so that the alarm relay completes a circuit (normally open) upon alarm activation.
o
Select Off so that the alarm relay is not activated (normally open) upon alarm activation.
9.
Enter a range for the web page automatic refresh interval in the Web Page Automatic Refresh Interval
field.
10.
Do one of the following:
o
Click Save Settings to save the information.
o
Click Clear Alarms to clear the alarms.
NOTE:
To clear the condensation pump cycles warning, click Cooling System in the left
navigation frame to access the Cooling System screen, and then click the Alarms/Warnings tab.
Under the Warnings section, set Alarm Reset to Manual and click Save Settings. Then, return to
the General menu and click Clear Alarms.
This step only clears the warning when the condensation pump is not running.
11.
Click Reset to Factory Defaults to reset the parameters to the defaults set by the factory. You are
prompted to reboot.
o
Click Restart to restart the management module.