HP Modular Cooling System - Manual (Page 31)

Web interface 31
If you enable NTP:
a. Enter the IP address of the primary NTP server in the Primary NTP Server field.
b. Enter the IP address of the secondary NTP server in the Secondary NTP Server field.
NOTE: If NTP is not enabled, selecting a time zone from the NTP GMT Offset dropdown box
changes the system clock by the hours offset.
c. Select the time zone from the NTP GMT Offset dropdown box.
d. Enter the number of hours that should pass between each date and time update in the NTP Update
Frequency field.
e. Click Save Settings to save the information or click Cancel to undo the changes.
f. Click Ping to test the network connectivity to another device IP address.
If you do not enable NTP:
a. Enter the date in the Date field on the General menu (on page 28 ).
b. Enter the time in the Time field on the General menu (on page 28 ).
c. Enter the date for DST to begin in the DST Begin field.
d. Enter the date for DST to end in the DST End field.
e. Click Save Settings to save the information or click Cancel to undo the changes.
f. Click Ping to test the network connectivity to another device IP address.
Management menu
Click Management in the left navigation frame to access the Management screen. This screen enables the
Admin to configure network management settings for the management module.
The Management screen contains the following:
• System Information tab (on page 31 )
• Trap Receivers tab (on page 32 )
• SNMP Managers tab (on page 33 )
• Remote Access tab (on page 33 )
System Information tab
This screen enables the Admin to enter contact information for the management module. The information
entered on this screen appears on the Identification screen and is included with SNMP traps sent by the
management module.
NOTE: The following screen is the same for either MCS-100 or MCS-200 units.