Snmp managers tab, Remote access tab – HP Modular Cooling System User Manual
Page 33
Web interface 33
3.
Enter the IP address for up to four trap recipients in the IP Address fields.
4.
To save the settings, choose one of the following options:
o
Click Save Settings to save the information.
o
Click Cancel to undo the changes.
5.
Click Send Test Trap to send a test SNMP trap to all enabled trap receivers.
SNMP Managers tab
This screen enables the Admin to enter information for SNMP managers. SNMP managers are computers
that use the MIB to request information and understand traps from the management module.
If all IP addresses are 0.0.0.0, all SNMP managers are allowed to request information from the module.
If one or more of the SNMP managers have an IP address, only those SNMP managers are allowed to
request SNMP information.
The SNMP manager entries do not have any effect on sending traps.
NOTE:
The following screen is the same for either MCS-100 or MCS-200 units.
To configure SNMP managers:
1.
In the IP Address field, enter the IP address for each SNMP manager.
2.
Do one of the following:
o
Click Save Settings to save the information.
o
Click Cancel to undo the changes.
Remote Access tab
This screen enables the Admin to enter information for remote access to the management module.
NOTE:
The following screen is the same for either MCS-100 or MCS-200 units.