HP XP Array Manager Software - Manual (Page 90)

LUN Manager Spreadsheet Settings
The following LUN Manager functions can be defined by using Configuration File Loader:
• Channel Adapter (CHA) settings allow you to change the PCB mode. See
“ Setting the CHA Mode ” on page 91.
• Port Settings allow you to change the settings for arbitrated loop-physical address (AL-PA), data
transfer speed (host speed), and topology. You can also change the LUN Security setting. See
“ Port Settings ” on page 92.
• Host Group Settings allow you to create, delete, or change the host group. See
“ Setting the Host Group ” on page 93.
• WWN settings allow you to add, delete or change the WWN information. See
“ Setting the WWN Information ” on page 95.
• LU path settings allow you to add, delete, or change LU paths. See
“ Setting the LU Path ” on page 96.
• Command Device settings and set or release the command device and command device security.
See “ Configuring the Command Devices ” on page 97.
Column Format
The LUN Manager spreadsheet allows you to write the settings for CHA mode, port, host group, WWN,
path definition, and command devices. The format of the LUN Manager spreadsheet is as follows:
• 1st column to 7th column: Current settings area
• 8th column to 10th column: Blank columns
• 11th column to 17th column: New settings area
The number of columns used depends on the function tag. If a particular function tag requires less than
seven columns, the unused columns are left blank.
Table 11 on page 91 describes the format of the LUN Manager spreadsheet.
90 Performing LUN Manager Operations Using Configuration File Loader