Device information, 23 the identity window – HP XP20000XP24000 Disk Array User Manual
Page 55
Figure 23 The Identity Window
The Information window has the following features:
•
Device Information (see “
•
LDEV Information (see “
•
The Apply button applies all the changes or settings made on the Remote Web Console main
window.
Note:
This button is active only when you select modify mode.
•
The Cancel button cancels the changes or settings made on the Remote Web Console main
window.
Note:
This button is active only when you select the modify mode.
Note:
If you input any changes, the text may be displayed in
blue bold italics
or an icon may change
(see
on page 30). The changes are not actually implemented until you select the Apply button.
Device Information
Device Information is on the upper part of the Information window.
•
Serial Number: Serial number of the connected storage system.
•
IP Address: IP address of the connected storage system (SVP).
•
Name: Device name of the connected storage system. The Remote Web Console user can
change the device name with the modify mode. You must enter a device name using up to 180
alphanumeric characters (ASCII codes), except for some symbols, such as ", \, ;, :, ,, *, ?, <,
>, |, /, ^, &, and %. You can also use a space, except for before and after the device name.
If you enter a space before or after the device name, an error occurs when you click Apply.
The device name is required to use SNMP Agent. For detailed information on SNMP, see the
HP StorageWorks XP24000 SNMP Agent Reference Guide.
Note:
Make sure to document the device name, because the settings will be cleared when
the SVP is replaced.
•
Contact: Contact information such as personnel and telephone number where you can inquire
about the connected storage system. The Remote Web Console user can change the contact
information with the modify mode. You must enter the contact information using up to 180
XP24000 Remote Web Console User’s Guide
55