Canon XF305 - Manual (Page 62)

Recording
62
3
Image Stabilizer
Image Stabilizer Use the image stabilizer to compensate for camcorder shake in order to
achieve steadier shots. There are 3 methods of image stabilization; select
the method that best suits your needs.
1 Open the [Image Stabilizer] submenu.
[l Camera Setup] [Image Stabilizer]
2 Select the desired option and then press SET.
• The icon of the selected mode appears on the bottom of the screen.
Options
NOTES
• By default, assignable button 1 is set to [Standard] but you can also set
it for another assignable button instead. You can press the button to
activate standard IS.
• If you set an assignable button to [Dynamic IS] or [Powered IS]
(0 117), you can press the button to turn the assigned mode on or
off.
• If the degree of camcorder shake is too high, the image stabilizer may
not be able to fully compensate.
• When you are using [Dynamic] mode, the edges of the picture may be
adversely affected (such as ghosting, artifacts and dark areas) when
compensating for a high degree of camcorder shake.
[l Camera Setup]
[Image Stabilizer]
[Standard]
Operating modes:
[Powered] Q: Powered IS is most effective when you are stationary and
zooming in on far subjects using high zoom ratios (the
more you approach the telephoto end). This mode is not
suitable for tilting and panning shots.
[Dynamic] P: Dynamic IS compensates for a higher degree of
camcorder shake, such as when shooting while walking,
and is more effective as the zoom approaches full wide
angle.
[Standard] O: Standard IS compensates for a lower degree of
camcorder shake, such as when shooting while remaining
stationary, and is suitable for shooting natural-looking
scenes.
[Off]: Use this setting when the camcorder is mounted on a
tripod.
COP
Y