Canon XF305 - Manual (Page 111)

111
Recording 3
Optical Axis Shift
Optical Axis Shift This function aids in a dual camera setup for 3D recording by allowing you
to adjust the position of the image stabilization lens.
1 Open the [Enable] submenu to activate optical axis shift.
[l Camera Setup] [Axis Shift] [Enable]
2 Select [On] and then press SET.
• Y appears on the bottom of the screen.
3 Open the optical axis [Adjust] screen.
[l Camera Setup] [Axis Shift] [Adjust]
• Four directional icons appear on the screen.
4 Use the joystick or wireless controller to adjust the picture.
• If the picture cannot be adjusted anymore in a particular direction, the
corresponding directional icon will turn gray.
• You can use the [l Camera Setup] [Axis Shift] [GUI Color]
setting to change the color of the icons and the [Reset] setting to
reset the position of the lens.
• You can check the lens position using the display on the lower right
of the screen.
5 Press SET when finished.
• If you press the CANCEL button, the lens will move back to its
position prior to adjustment.
NOTES
• The range of adjustment depends on the current zoom position.
• The more the lens position is adjusted, the bigger the deviation at the
center of the picture will be during zoom. By centering on an object at
full telephoto and then adjusting at full wide-angle, the amount of
amount of deviation will be reduced.
Operating modes:
[l Camera Setup]
[Axis Shift]
[Enable]
[Off]
[l Camera Setup]
[Axis Shift]
[Adjust]
COP
Y