Canon XF305 - Manual (Page 126)

Customization
126
4
Custom Picture Settings
Sharpness
Sets the sharpness of the output and recording signal.
[Level]: Sets the sharpness level. This setting can be adjusted
from -10 to 50. (Default: 0)
[H Detail Freq.]: Sets the center frequency of horizontal sharpness.
Setting higher values increases the frequency, which, in
turn, increases the sharpness. This setting can be
adjusted from -8 to 8. (Default: 0)
[Coring]: Reduces noise artifacts caused by high sharpness levels.
[Level]: Sets the coring level. Higher values prevent sharpness from
being applied to minute details, resulting in less noise. This setting can
be adjusted from -30 to 50. (Default: 0)
[D-Ofst]: You can use [D-Ofst], [D-Curve] and [D-Depth] to adjust the
coring level based on brightness. [D-Ofst] sets the coring level of the
minimum brightness level. This setting can be adjusted from 0 to 50.
(Default: 0)
[D-Curve]: Sets the curve of the coring adjustment. This curve is the
change from [Level] to [D-Ofst]. This setting can be adjusted from 0 to 8.
(Default: 0)
[D-Depth]: Sets a multiplier to [D-Ofst] that determines the coring level
adjustment based on brightness. Positive values raise the coring level
in dark areas and negative values lower the level. This setting can be
adjusted from -4 to 4. (Default: 0)
[HV Detail Bal.]: Adjusts the ratio between horizontal and vertical detail.
Higher values emphasize vertical detail while lower values
emphasize horizontal detail. This setting can be adjusted
from -8 to 8. (Default: 0)
[Limit]: Restricts how much sharpness is applied. This setting
can be adjusted from -50 to 50. (Default: 0)
Input
Outp
ut
Input
Outp
ut
Knee Slope Knee Point
COP
Y