Brother FAX-T94 - Manual (Page 125)

MESSAGE MANAGER 9 - 16
Remote Control Commands
Follow the commands below to access features remotely. When you
call the fax machine and enter your Remote Access Code (3 digits
followed by
), the system will signal you with two short beeps to
enter a remote control command.
Remote control commands Detail Operation
91 Playing voice messages After one long beep, the machine plays ICM.
1 Skip back Press 1 while listening to an ICM to play it again. If
you press 1 before a message, you will hear the
previous message.
2 Skip next While playing ICM, you can skip to next message.
9 STOP Playing Stop playing the ICM.
93 Erase all ICM If you hear one long beep, the erase is accepted. If
you hear three short beeps, you cannot erase
because all voice messages have not been played,
or there is no voice message to erase.
*This code erases all recorded messages, not one
at a time.
94 Play and Record OGM in
memory
1 Play 1 TAD MSG The machine plays the selected OGM. You can
stop playing OGMs by pressing 9.
2 F/T MSG
3 PAGING MSG
2
Record 1 TAD MSG After one long beep, you can record the selected
OGM. You will hear the message played once. You
can stop recording the message by pressing 9.
2 F/T MSG
3 PAGING MSG
95 Changing Fax
Forwarding/Paging
setting
If you hear one long beep, the change is accepted.
If you hear three short beeps, you cannot change it
because the conditions have not been met
(Example: registering paging number).
You can register your fax forwarding number by
using 4.FAX FWD NO. (See Changing the Fax
Forwarding Number on page 9-19.) Once you have
registered the number, the machine will
automatically turn to “FAX FWD:ON” mode. Then
retrieve a Memory Status List by entering 9 6 1 to
make sure that the Fax Forwarding number you
registered is correct in the List.
1 OFF
2 Fax Forwarding
3 Paging
4 Fax Forwarding
number