Brother MFC-J410W - Manual (Page 72)

65
5
5
Network menu
5
Before using your Brother product in a network environment, you need to configure the correct TCP/IP
settings.
In this chapter, you will learn how to configure the network settings using the control panel, located on the
front of the machine.
The Network menu selections of the control panel allow you to set up the Brother machine for your network
configuration. Press Menu, then press a or b to choose Network. Proceed to the menu selection you wish
to configure. (See Function table and default factory settings on page 109.)
Please note that the machine is supplied with the BRAdmin Light software and Remote Setup applications
for Windows
®
and Macintosh, which also can be used to configure many aspects of the network. (See
Configuring your machine for a network with an Ethernet cable connection (DCP-J715W, MFC-J615W and
MFC-J630W only) on page 9 for a wired connection or Changing the print server settings on page 15 for a
wireless connection.)
TCP/IP
5
If you connect the machine with an Ethernet cable to your network, use the Wired LAN menu selections. If
you connect the machine to a wireless Ethernet network, use the WLAN menu selections. (DCP-J715W,
MFC-J615W and MFC-J630W only)
This menu has 9 sections: BOOT Method, IP Address, Subnet Mask, Gateway, Node Name,
WINS Config, WINS Server, DNS Server and APIPA.
BOOT Method
5
This selection controls how the machine obtains an IP address. The default setting is Auto.
Note
If you do not want your print server configured via DHCP, BOOTP or RARP, you must set the
BOOT Method to Static so that the print server has a static IP address. This will prevent the print server
from trying to obtain an IP address from any of these systems. To change the BOOT Method, use the
machine’s control panel, BRAdmin Light utility or Remote Setup.
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c
For DCP-J715W, MFC-J615W and MFC-J630W
(For Wired) Press a or b to choose Wired LAN, and press OK.
(For Wireless) Press a or b to choose WLAN, and press OK.
d Press a or b to choose TCP/IP.
Press OK.
Control panel setup
5