Brother MFC-J410W - Manual (Page 39)

Configuring your machine for a wireless network
32
3
Using WPS or AOSS™ from the control panel menu to configure your machine
for a wireless network
3
If your wireless access point supports either Wi-Fi Protected Setup (PBC
1
) or AOSS™ (one-push method),
you can configure the machine easily without a computer. Your Brother machine has the WPS/AOSS™ menu
available from the control panel. This feature automatically detects which mode your access point uses, Wi-Fi
Protected Setup or AOSS™. By pushing a button on the wireless access point/router, you can setup the
wireless network and security settings. See the User’s Guide for your wireless access point/router for
instructions on how to access one-push mode.
1 Push Button Configuration
Note
Routers or access points that support Wi-Fi Protected Setup or AOSS™ have the appropriate symbols
shown below.
a Press Menu.
b Press a or b to choose Network.
Press OK.
c For DCP-J715W, MFC-J615W and MFC-J630W
Press a or b to choose WLAN.
Press OK.
d Press a or b to choose WPS/AOSS.
Press OK.
This feature will automatically detect which mode (Wi-Fi Protected Setup or AOSS™) your access point
uses to configure your machine.
Note
If your wireless access point supports Wi-Fi Protected Setup (PIN Method) and you want to configure your
machine using the PIN (Personal Identification Number) Method, see Using the PIN Method of Wi-Fi
Protected Setup on page 34.
e When Enable WLAN? or Network I/F switched to Wireless. is displayed, press OK to
accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.