Brother MFC-J410W - Manual (Page 34)

Configuring your machine for a wireless network
27
3
Configuring your machine for a wireless network
3
IMPORTANT
• If you are going to connect your Brother machine to your network, we recommend that you contact your
system administrator prior to installation. You must know your wireless network settings before you
proceed with this installation.
• If you have previously configured the wireless settings of the machine, you must reset the network LAN
settings before you can configure the wireless settings again.
Press Menu, a or b to choose Network, press OK. Press a or b to choose Network Reset, press OK.
Press 1 or + to reset and then press 1 or + to accept the change. The machine will restart automatically.
Using the Setup Wizard from the control panel
3
You can configure your print server by using the Setup Wizard function. This is located in the Network
menu on the machine’s control panel. See to the steps below for further information.
Configuring your machine for an existing wireless network
3
a Before configuring your machine we recommend you write down the SSID and Password (Network Key)
(if required) for your wireless network. You will need this information before you continue with the
configuration. If your wireless access point/router is set to not broadcast the SSID Name, see
Configuring your machine when the SSID is not broadcast on page 29.
Note
If your router uses WEP encryption, enter the key used as the first WEP key. Your Brother machine
supports the use of the first WEP key only.
b Press Menu.
c Press a or b to choose Network.
Press OK.
d For DCP-J715W, MFC-J615W and MFC-J630W
Press a or b to choose WLAN.
Press OK.
e
Press a or b to choose Setup Wizard.
Press OK.
Item Record the current wireless network settings
Network name: (SSID/ESSID)
Password (Network Key)