Brother TD-2120N - Manual (Page 21)

Printing
15
2
Inserting the RD Roll
2
a
Press and hold the (Power) button to
turn the printer off.
Press the cover release lever (1) on
either side and lift up to open the RD
Roll compartment top cover.
b
Open the media guides by lifting up the
media guide adjustment lever (1) and
pulling the media guides outwards.
NOTE
The media guides are shipped fully open
from the factory.
c
Insert an RD Roll into the RD Roll
compartment, and then close the RD
Roll compartment top cover.
 For an RD Roll
1 Insert the RD Roll so that the
labels feed with the side to be
printed on facing up (1), as
shown.
Use genuine Brother roll media.
Genuine Brother fanfold media is not
available at this time.
1
1
 Use RD Rolls with an outer roll
dimension of 5" (127 mm) or less.
Use RD Rolls designed for TD
series printers. Regardless of the
size, some RD Rolls may not be
usable.
 Insert the RD Roll facing the correct
direction. If the RD Roll is not
inserted correctly, the printer will not
print on the correct side of the paper
or label.
 When using media with the labels
rolled up on the inside, insert the roll
in the opposite direction of that
shown in sub-step 1 of step c so
that the print side of the labels will
face up.
1