Brother TD-2120N - Manual (Page 118)

Chapter 14
112
Removing the Rechargeable Li-ion
Battery
14
Follow the procedure for installing the
rechargeable battery to remove the battery
cover, and then remove the battery and
reattach the cover.
CAUTION
If it is difficult to remove the rechargeable
battery, turning the printer over with the
battery cover removed may allow the
rechargeable battery to fall out.
Be careful that this does not cause any
injuries.
Charging the
Rechargeable Li-ion
Battery
14
The rechargeable Li-ion battery can be
charged while it is installed in the printer.
The battery is recharged when the AC
adapter is used while the battery as well as
the battery base are attached to the printer. In
addition, if the 4 bay battery charger
(optional) is used, the battery can be
recharged without using the printer.
The procedure for charging using the AC
adapter is described here. To charge using
the 4 bay battery charger (optional), refer to
the instruction manual for the optional
equipment.
NOTE
• Up to 5 hours is needed to fully charge a
rechargeable Li-ion battery.
• You can print about 656.2 ft (200 m) using
a new, fully charged battery. (Tested at
73.4
F (23 C) using Brother’s print test
data (2.25" (57 mm), 9 % coverage) when
connected by USB.)
• Before using the rechargeable Li-ion
battery, use the following procedure to
charge it.
a
Make sure that the rechargeable Li-ion
battery and the battery base are
installed on the printer.