Brother MFC-820CW - Manual (Page 40)

Control panel setup
4 - 7
4
5.Node Name
You can register the machine name on the Network. This name is often referred to as a NetBIOS name; it will
be the name that is registered by the WINS server on your network. Brother recommends the name
BRN_xxxxxx for a wired network or BRW_xxxxxx for a wireless network (where xxxxxx is the last six digits of
the Ethernet address) (up to 15 characters).
(For MFC-640CW)
1
(For Wired) Press Menu/Set, 5, 1, 5.
(For Wireless) Press Menu/Set, 5, 2, 5.
2
Select 1 to change. Enter the Node Name.
3
Press Menu/Set.
4
Press Stop/Exit.
(For MFC-820CW)
1
Press Menu.
2
Press ▲
or
▼
to select LAN.
Press OK.
3
(For Wired) Press ▲
or
▼
to select TCP/IP(Wired).
(For Wireless) Press ▲
or
▼
to select TCP/IP(WLAN)
Press OK.
4
Press ▲
or
▼
to select Node Name.
Press OK.
5
Press ▲
or
▼
to select Change.
Press OK.
6
Enter the Node Name.
Press OK.
7
Press Stop/Exit.