Brother MFC-820CW - Manual (Page 158)

Appendix B
B - 5
B
1. The factory setting for IP Address may be changed by the APIPA setting.
2. The factory setting for Subnet Mask may be changed by the APIPA setting.
5.LAN 3.Setup
WLAN 1.Setup Wizard Searching SSID Select SSID & Set
(Select SSID from list or manually add
SSID)
—
2.SecurEasySetup Connecting WLAN/
Connected/
Connection Error — —
4.WLAN
Status 1.Status Active(802.11b)/
Active(802.11g)/
Disabled/
Searching SSID — —
2.Signal Strong/ Medium/
Weak/ None — —
3.SSID (Shows SSID with
less than 33 digits) — —
4.Comm.Mode Ad-hoc/
Infrastructure — —
5.Security Mode WEP/ WPA-PSK/
None KEY1/ KEY2/ KEY3/ KEY4 (when WEP
is selected) —
5.Setup
Misc. 1.Wired LAN Auto/ 100B-FD/
100B-HD/ 10B-FD/
10B-HD — Auto
2.Time Zone GMTXXX:XX — GMT-00:00
6.Network
I/F Wired LAN Reboot OK? 1.Yes/ 2.No Wired LAN
Accepted —
WLAN Reboot OK? 1.Yes/ 2.No
Accepted —
0.Factory
Reset 1.Reset 1.Yes — —
2.No — —
2.Exit — — —
Level
one Level two Level three Options 1 Options 2 Factory settings