Brother MFC-820CW User Manual
Page 141
Wireless installation for Macintosh
®
9 - 31
9
17
Enter a new SSID and choose Authentication
Method and Encryption Mode from the pull-downs
in each setting box. Then enter the Network Key
and click Next.
Note
If you do not know the Authentication or Encryption settings for network, contact your network administrator.
18
Click Next. The settings will be sent to your
machine. The settings will remain unchanged if you
click Cancel.
Note
If you want to manually enter the IP address settings of your machine, click Change IP Address and enter
the necessary IP address settings for your network. After making your selection, click Next and the Wizard
will search for available wireless networks.
19
To communicate with the configured wireless
device, you must configure your Macintosh
®
to use
same wireless settings. Manually change the
wireless settings on your Macintosh
®
to match the
machine’s wireless settings shown on this screen.
Click Next.
(The settings shown on this screen are for example
only. Your settings will not be the same.)
You have completed the wireless setup. A four level indicator of your machine’s LCD
represents the wireless signal strength. If you chose to install the drivers in