Brother MFC-820CW User Manual
Page 115
Wireless installation for Macintosh
®
9 - 5
9
Note
If you choose This PC uses a network cable to
connect to the wireless network., you must configure
the wireless settings from the control panel. Click Next
and follow the on-screen instructions to complete the
setup. When finished, go to the driver installation in
23.
12
Read the Important Notice.
For MFC-640CW: Press Menu/Set, 5, 6 on the
control panel, and then press
▲
or
▼
to choose WLAN.
Press Menu/Set. If Reboot OK? is displayed, press
1.Yes. The wired network interface will become
inactive with this setting. The machine will restart
automatically. After it restarts, check the box on the
screen and click Next.
For MFC-820CW: Press Menu on the control panel.
Press
▲
or
▼
for
LAN and press OK. Press
▲
or
▼
for
Network I/F and press OK. Press
▲
or
▼
for
WLAN
and press OK. If Reboot OK? is displayed, press 1 for
Yes. The wired network interface will become
inactive with this setting. The machine will restart automatically. After it restarts, check the box on the
screen and click Next.
If Accepted is displayed, press Stop/Exit. Check the box and click Next.
Note
It will take approximately one minute for the LAN menu to become available after the machine restarts or is
turned on.
You need to temporarily change the wireless
settings of your Macintosh
®
. Please follow the
on-screen instructions. Please make sure you take
notes on all the settings such as SSID or channel of
your Macintosh
®
. You will need them before you
finish your setup.