beautypg.com

Change basic parameter, Changing the basic unit, Setup change basic parameter – ROTRONIC LOG-HC2 Universal Datalogger User Manual

Page 36

background image

36

Setup

Change basic parameter

Change basic parameter is used to adapt the factory settings (name, unit,

display format) to your requirements . These details are used among others, for

calibration purposes .

Select the desired channel (e .g . analogue input A2) and then click

Change ba-

sic parameter . Enter your adjustments 5 (e .g . Mbar instead of Volt) .

To enter the conversion factor (e .g . Volts to Mbar) the following options are avail-

able:

• Enter the

amplification and the zero point

• Using the calculation assistant 6 enter the values for points P1 and P2 7 .

The program will then calculate the amplification and the zero point .

Activate

Apply user information by checking the checkbox 4 and then click

OK . Transfer the changes to the logger by clicking Write user settings .

Note: Should you wish to use a different display unit to that used for calibration,

then please use the function

Change display parameter .

3

4

6

6

Max . 4 characters

Changes have been made to this channel .

7

5

Resetting channel properties to the factory settings:

Uncheck checkbox 4 (

Apply user information) and transfer the changes to the

logger by clicking

Write user settings .