Instructions – ROTRONIC LOG-HC2 Universal Datalogger User Manual
Page 11
Instructions
11
Turning the unit on / saving measurement parameters
The storage properties of the logger are determined using the
Setup program* .
Control of measurement parameter storage can be either time activated, value
activated or by pushing the push button .
See also chapter „Logger display / Logger operation“ on page 12 .
*
Setup is an LOG PC program (see below) .
See also other documents in the category ROTRONIC Tools:
- HL-20-CAL (4 pages)
- Hygrogen2 (75 pages)
- Hygrogen2 (1 page)
- MBW 373 (49 pages)
- MBW 473 (53 pages)
- MBW 973 (42 pages)
- CO2 Display (1 page)
- HL-DS-XX (2 pages)
- HL-DS-XX (15 pages)
- HygroLog HL-NT (2 pages)
- HygroLog HL-NT (48 pages)
- HygroLog HL20 (17 pages)
- LOG-HC2 Universal Datalogger (2 pages)
- CP11 (1 page)
- GTS (4 pages)
- HP22A (4 pages)
- HP21 (14 pages)
- HP22A (16 pages)
- HP23-A (37 pages)
- HC2 (2 pages)
- HC2 (31 pages)
- HC2 (23 pages)
- HygroLog HL-1D (4 pages)
- HC2-S3C03 (1 page)
- HM4 (4 pages)
- HM4 (41 pages)
- HygroMet MP102H (2 pages)
- HygroMet MP102H (20 pages)
- MP100A (20 pages)
- MP100H (19 pages)
- MP400A (17 pages)
- RS12 (17 pages)