Prochem Legend SE AD - Manual (Page 30)

OPERATION
LEGEND SE 980059 06/19/03 3-22
FLOOD RESTORATION
Set the temperature control on the control panel
to 50°.
SHUTDOWN AND DAILY MAINTENANCE
1. Run fresh water through the chemical injection
system to flush out chemicals.
2. We recommend removing as much moisture from
your vacuum hoses as is reasonable. This will
prevent spillage of solution in your vehicle when
replacing hoses.
3. Position the throttle control to about 3/4 of the
way out, but no less than 1/2 of the way out.
4. Disconnect the vacuum hoses from the unit.
5. Set temperature dial to 50°, and allow the unit to
cool down to 180
°
F or less.
6. Push the throttle all the way in to idle and allow
the unit to run for 1 minute in order to remove all
moisture from the vacuum pump.
NOTE: If finishing for the day: Pull the throttle all
the way out, plug the vacuum inlet and spray WD-
40 (or equivalent) into the vacuum lubrication cup
(located at front of console) for 5 seconds. This
will lubricate the vacuum pump. Pull the throttle
back to idle and continue to step #7.
7. Turn the ignition switch to the OFF position.
8. Turn the water supply faucet off. Bleed the
pressure out of the water supply hose by
loosening the hose at the water supply. Unhook
the water supply hose and store in vehicle.
9. Relieve pressure from the cleaning tools and
pressure hoses by activating the valve on the
tools. Disconnect the tools and pressure hoses
from the unit and store all items.
10. Drain the waste tank and dispose of waste in a
proper manner.
NEVER dispose of waste in storm drains, water
ways, or on ground areas. Always dispose of
waste in accordance with Local, State, and
Federal laws.
11. Remove the strainer basket from the waste
tank, clean out any accumulated debris, and re-
install. Inspect the vacuum inlet filter inside the
waste tank. If there is any lint or debris, remove
and clean filter.
NOTE: When removing the vacuum inlet filter,
grip the plastic hexagonal section of filter.
Grasping filter by the screen may collapse or ruin
the filter. Re-install the filter hand-tight. NEVER
operate this unit with this filter removed,
damaged or improperly installed.
NOTE: When replacing this filter, we recommend
using the stainless steel Prochem filter,
Part #14-806518, only.
12. At the end of your work day, rinse out the waste
tank with fresh water. DUO Deodorizer may be
added to the waste tank to inhibit the growth of
bacteria.
13. Clean the unit, tools, hoses, van interior, etc., as
needed. Inspect ALL equipment for any damage,
wear, leaks, etc.