PNI FieldForce Trax - Manual (Page 35)

PNI Sensor Corporation DOC#1016505 r06
TRAX User Manual Page 31
Start/Stop Testing
Clicking the button results in the Heading, Pitch, and Roll values being
updated on the Test Tab screen, as well as the Heading Status.
If the Acquisition Mode is set to “Continuous”, then the data will be continuously
updated. The button will change to read , such that clicking it again will stop
the screen from updating.
If the Acquisition Mode is set to “Single”, then only one measurement will be
displayed on the screen. The button will briefly gray out while the data is being
output to the screen, then return to reading .