PNI FieldForce Trax - Manual (Page 28)

PNI Sensor Corporation DOC#1016505 r06
TRAX User Manual Page 24
6.4.1 General Settings
Baud Rate
The baud rate can be altered by selecting the desired baud rate from the pull down
menu, clicking on “Save”, and then powering the device off and back on. The new
baud rate will not take effect until the device has been powered off/on. The default
baud rate is 38400.
Mounting
TRAX Studio supports 16 mounting orientations, as previously illustrated in Figure
4-2. The default is “Standard”.
Output Units
The TRAX can output heading, pitch, and roll in either degrees or mils. The default
is “Degrees”. (There are 6400 mils in a circle, such that 1 degree = 17.7778 mils and
1 mil = 0.05625 degree.)
North Reference
When “Magnetic” is selected, the heading output will be relative to magnetic north.
When “True” is selected, heading will be relative to true north, and the declination
value should be entered in the next field. The default is “Magnetic”.