NORD Drivesystems BU0090 - Manual (Page 70)

NORDAC AS-Interface Manual
70 BU 0090 GB
9 Additional information
9.1 Maintenance and servicing information
In normal use, NORDAC frequency inverters and their accessories are maintenance-free.
If air intake filters have been built into the control cabinet, then these should also be regularly cleaned or
replaced.
If you contact our technical support, please have the precise device type (rating plate/display), accessories
and/or options, the software version used (P707) and the series number (rating plate) at hand.
Repairs
The device must be sent to the following address if it needs repairing:
NORD Electronic DRIVESYSTEMS GmbH
Tjüchkampstr. 37
26605 Aurich, Germany
For queries about repairs, please contact:
Getriebebau NORD GmbH & Co. KG
Tel.: 04532 / 401-515
Fax: 04532 / 401-555
If a frequency inverter or accessories are sent in for repair, no liability can be accepted for any added
components, e.g. such as line cables, potentiometer, external displays, etc.!
Please remove all non-original parts from the frequency inverter.
NOTE
If possible, the reason for returning the component/device should be stated. If necessary, at
least one contact for queries should be stated.
This is important in order to keep repair times as short and efficient as possible.
On request you can obtain a suitable goods return voucher from Getriebebau NORD GmbH.
Internet information
You can find the comprehensive manuals in German and in English on our Internet site.
www.nord.com
9.2 Abbreviations in this manual
AS-i ......Actuator Sensor Interface
ASIC .....Application Specific Integrated Circuit
AUX .......Auxiliary (auxiliary power supply)
IND ........Index
IP ..........International Protection
IW ..........Actual value
LAS ....... List of Active Slaves
LES ....... List of detected slaves
LPS ....... List of designed slaves
n.c. ........not connected / free
PELV .....Protective Extra Low Voltage
PKE .......Parameter label
PKW ......Parameter range
PNU ......Parameter number
PWE ......Parameter value
PWR ......Power
PZD .......Process data
ZSW ......Status word