NORD Drivesystems BU0570 - Manual (Page 3)

EtherCAT bus module for NORD frequency inverters SK 5xxE About this document
BU 0570 GB-0312 Subject to technical amendments 3
Documentation
Designation: BU 0570 GB
Part No.: 607 57 02
Device series: SK TU3-ECT (EtherCAT® - Bus module) for SK 5xxE (entire series)
Version list
Designation of previous versions Software
Version Remarks
BU 0570 GB, June 2009
Part No. 607 5701 V 1.0 R0 First issue
BU 0570 GB, Jan 2010
Part No. 607 5701 / 0410 V 1.0 R1 The trademark entry for the firm Beckhoff was amended in
the introduction
BU 0570 GB, April 2010
Part No. 607 5701 / 1710 V 1.0 R1 Replacement of Fig. 3, correction of spelling errors in
parameter (P172).
BU 0570 GB, Jan 2012
Part No. 607 5701 / 0312 V 1.4 R0 Extension to frequency inverter SK 54xE
Publisher
Getriebebau NORD GmbH & Co. KG
Rudolf- Diesel- Str. 1  D-22941 Bargteheide  Germany ### http://www.nord.com/
Tel.: +49 (0) 45 32 / 401-0  Fax +49 (0) 45 32 / 401-555
NOTE
This supplementary operating manual is only valid in conjunction with the operating manual
supplied for the respective frequency inverter (Manual BU0500).
Intended use of the frequency inverter
The compliance with the operating instructions is necessary for fault-free operation and
the acceptance of possible warranty claims. These operating instructions must be read
before working with the device!
These operating instructions contain important information about servicing. They must
therefore be kept close to the device.
The Ethernet module can only be used for the defined frequency inverter series (SK500E).
The use of this module with other devices is not permitted and can lead to their destruction.
The Ethernet module and the associated frequency inverter are devices for fixed installation
in control cabinets. All details regarding technical data and permissible conditions at the
installation site must be complied with.
Commissioning (implementation of the intended use) is not permitted until it has been
ensured that the machine complies with the EMC directive 2004/108/EEC and that the
conformity of the end product meets the machine directive 2006/42/EEC (note EN 60204).
 Getriebebau NORD GmbH & Co. KG, 2012