Dwyer 2600 - Manual (Page 32)

I n P Input Type: Select one of the following. Refer to the Wiring section for the proper
wiring.
J - I C Type “J” Thermocouple
C A Type “K” Thermocouple
E - Type “E” Thermocouple
t - Type “T” Thermocouple
L - Type “L” Thermocouple
n - Type “N” Thermocouple
r - 1 3 Type “R” Thermocouple
S - 1 0 Type “S” Thermocouple
b - Type “B” Thermocouple
C - Type “C” Thermocouple
P 3 9 2 100 ohm Platinum (NIST 0.00392 Ω/Ω/°C)
n 1 2 0 120 ohm Nickel
P 3 8 5 100 ohm Platinum (IEC/DIN 0.00385 Ω/Ω/°C)
1 P 3 8 1000 ohm Platinum (IEC/DIN 0.00385 Ω/Ω/°C)
C u r r DC Current Input 0.0 to 20.0 or 4.0 to 20.0 mA.
U o L t DC Voltage Input 0.0 to 10.0 or 1.0 to 10.0 volts.
d i F F DC Voltage Input -10 to +10 mV.
- - - - Reserved
O S U P Zero Suppression: Select O n or O F F . Only with Current and Voltage input types.
O F F
The input range will start at 0 (zero) Input.
O n The input range will start at 4.00 mA or 1.00 V.
U n i t F , C or n o n E .
F
°F descriptor is On and temperature inputs will be displayed in actual
degrees Fahrenheit.
C °C descriptor is On and temperature inputs will be displayed in actual
degrees Celsius.
n o n E °F and °C descriptors will be Off. This is only available with Current and
Voltage Inputs.
d P t Decimal Point Positioning: Select 0 , 0 . 0 , 0 . 0 0 , 0 . 0 0 0 , o r . 0 0 0 0 . On
temperature type inputs a change here will alter the Process Value, SP1, SP2,
ALLo, ALHi, and InPC. For Current and Voltage Inputs all Menu Items related to
the Input will be affected.
0
No decimal Point is selected. This is available for all Input Types.
0 . 0 One decimal place is available for Type J, K, E, T, L, RTD’s, Current and
Voltage Inputs.
0 . 0 0 Two decimal places is only available for Current and Voltage Inputs.
0 . 0 0 0 Three decimal places is only available for Current and Voltage inputs.
May, 2013 Page 32 of 52 949-1194 Rev. 7