Models, In the – Crystal FastCalXP Calibration Software User Manual
Page 38
Managing the Database
36
FastCalXP Operation Manual
MODELS
The Models editor allows access to the data associated with all models stored in the database.
Model
The
Model
name is normally simply the name of the model provided by the manufacturer. However, if you wish use diff erent test profi les on diff erent groups of
a single manufacturer’s model, you may need to add a modifi er to the model name that will help you recognize which test profi les will be used for calibration.
Manufacturer
Use the pull-down list to select a
Manufacturer
from those stored in the database.
Units of Measure
Use the pull-down lists to select the
Units of measure.
Pressure Range
Specify the
Pressure range
and the value associated with each tic or
Resolution
of the gauge.
AR and AL Test Profi les
From the pull-down lists, select test profi les for As Received
(AR)
and As Left
(AL)
calibrations. Specify the number of runs through each profi le, or
Qty
.
If the
desired profi le is not listed, click on
Create New Profi le
to open the Profi les editor.