Crystal FastCalXP Calibration Software - Manual (Page 33)

Settings and Options  31
FastCalXP Operation Manual
  
WHERE SETTINGS ARE STORED
While most settings and options are stored within the database, some settings, such as the serial port, are stored separate from the database and apply to all
databases. If you are only working with a single database, you can ignore this section as it will have no aff ect on you. However, if you use multiple database
support, it is important to understand that some settings are unique to the database you are using, while others only need to be set once for all databases.
The following settings apply to all databases and only need to be set once:
 Options Dialog: Confi g Settings tab
•
Multiple database support
•
Language selection
•
XP2/Model 30 serial port
•
HART Modem serial port
 Options Dialog: Calibration Settings tab
•
Calibration method
•
Peak detection settings
•
Head correction
 Options Dialog: Security Settings tab
•
All security settings except certifi cate password.
 Change Database dialog
•
Choosing database on startup setting
All other settings are stored within the database. This means that when you change any setting not included in the list above, it aff ects only the current
database. If you want to change a setting not in the list above, but have it aff ect all of your databases, you will need to switch to each database and make the
change.
  