Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities - Manual (Page 60)

Initial Setup
1 Install the battery
The Lithium-Ion (Li-Ion) battery is shipped detached
from the unit Insert the battery at the bottom of the
compartment first so the connector on the battery makes
contact with the pins in the battery compartment
Using the flat end of the stylus or a coin, turn the latch
located above the battery clockwise until tightened As
the latch is turned, the battery levels in the case
2 Attach the hand strap, starting at the bottom
Push the clip of the hand strap into the hooks on the battery door at the bottom of the handheld at a 180 degree
angle until it snaps into place
Fold the top clip of the hand strap backwards so that it can be pushed into the top hooks of the handheld
Pull up on the strap and push the clip into the top hooks at a 180 degree angle until it snaps into place
The hand strap is now securely attached
IMNOOTAO I
Make sure to hold the clip straight, parallel to the hooks, and push it in at a 180 degree angle to ensure proper
installation.
3 Screw on the external antenna (P/N: 66238-007) If the handheld is not equipped with a radio, skip to step 4
4 Charge the battery
The power supply that ships with the handheld has four international plugs Connect the appropriate plug to the
power cord and attach to the power supply
Plug into an electrical outlet and plug the barrel end of the power supply into the unit
The battery can also be charged using the docking station
NOTE: N For more information on the battery, see "working with the handheld Battery" on page 62
TRIMBLE RANgER 3 hANdhELd OVERVIEw
Page 60 April 2014 ORION® Field Application for Trimble® Ranger 3