West Control Solutions KS 94 - Manual (Page 9)

9. Operation (survey)
+ The user manual (order no. 9499 040 44811) is required for the complete operation.
9.1 The menues 1...3
Apart from the parameter and configuration words, the following dialogue words are used (Text1):
Text1 Signification
CBus CFrnt PC communication via interface at terminals B12...B16 or connection on the unit front
Clear The additional display selected at operating level is deleted (r Mark)
Clock Adjust the clock
Conf Transition to configuration level
End Return to the previous selection menu
Exit Return to operating level (main display)
Hold The displayed parameter is determined as standard indication.
Mark The displayed parameter is stored as additional display at operating level (r Clear)
More The configuration level area described with MORE is accesible
OStar OStop Self-tuning will be started or stopped
Para Transition to parameter level
PRun PStop Programmer will be started or stopped
PSet PRes Programmer will be set to a specified program point or reset to the reset point
Quit Return to operating level (main display) without storage of the values changed last
9.2 The operating level
The operating level comprises main display Ü and extension *. During the main display, automatic
or manual operation can be selected (H). With automatic, the set-point, and with manual, the
correcting value can be adjusted directly (ID). In the extension, the number and sequence of
displays is dependent of selected functions. Max. 12 parameters from the parameter level can be
displayed (Mark i Clear). Some of these parameters are directly adjustable (ID). A parameter
can be displayed continuously with the Hold function. (PressM < 3s Ä Select parameter (press
ID) Ä M > 3s Ä Select Hold (Press ID) Ä M). The extension can be left with Exit and M
or after a timeout of 60 s or with H. With H, the other operating mode is also selected.
+ If the set-point is set to ‘——‘ by means of D, the controller is switched off!!
Menu 1 is always selectable at operating level: deletion of additional display (Clear),
communication interface switch-over (CBus i CFrnt) and starting (OStar) or stopping
(OStop) the self-tuning, setting the clock (Clock), operate the programmer (PRun i PStop;
PRes; PSet) and transition to parameter level (Para).
Operation (survey)
11 Operating instruction KS94