West Control Solutions N8100 - Manual (Page 6)

1.2 DISPLAYS AVAILABLE
After the Controller has performed its power-up self-test (during which, if the
Function key is held down during power-up, the current Controller firmware
revision is displayed), the initial displays appear. The available displays are
dependent upon (a) whether the Controller has been configured for Single
Setpoint operation or Dual Setpoint operation and (b) the setting of the Setpoint
Strategy parameter in Set Up Mode.
1.2.1 Single Setpoint Operation
In single setpoint operation, the available displays are:
1-2 O054-1
59125