West Control Solutions N8100 - Manual (Page 42)

The procedure to panel-mount the Controller is shown in Figure 1-3.
CAUTION: Do not remove the panel gasket, as this may result in inadequate
clamping of the instrument in the panel.
NOTE: The mounting clamp tongues may engage the ratchets either on the
sides of the Controller housing or on the top/bottom faces of the Controller
housing. Therefore, when installing several Controllers side-by-side in one
cut-out, use the ratchets on the top/bottom faces.
1-2 O054-1
59125
Figure 1-2 Main Dimensions