KROHNE OPTIWAVE 7300C EN - Manual (Page 77)

OPERATION
6
77
OPTIWAVE 7300 C
www.krohne.com 03/2014 - 4000172405 - HB OPTIWAVE 7300 R07 en
How to check the measurement quality
• Enter supervisor mode.
• Go to Test > Information > Measurement Quality
Test > Information > Measurement Quality Test > Information > Measurement Quality Test > Information > Measurement Quality.
i This shows the status of device errors at this time. A "tick" symbol next to an error in the
list shows that this error is active and may have an unwanted effect on the device.
• For solutions to the problem, refer to Error handling on page 79.
Figure 6-10: Measurement quality in supervisor mode
1 Type of error.
2 Error "active"