KROHNE OPTIWAVE 7300C EN - Manual (Page 47)

START-UP
5
47
OPTIWAVE 7300 C
www.krohne.com 03/2014 - 4000172405 - HB OPTIWAVE 7300 R07 en
5.3.4 How to start the device
• Connect the converter to the power supply.
• Energize the converter.
i After 30 seconds the screen will display "booting up", "starting up" and then the default
screen will appear.
• The device will display readings.
i Measurements agree with specifications given in the customer order.
5.4 Remote communication with PACTware™
PACTware™ displays measurement information clearly on a computer (PC) and lets you
configure the device from a remote location. It is an Open Source, open configuration software
for all field devices. It uses Field Device Tool (FDT) technology. FDT is a communication standard
for sending information between the system and the field device. This standard agrees with
IEC 62453. Field devices are easily integrated. Installation is supported by a user-friendly
Wizard.
Install these software programs and equipment:
• Microsoft
®
.NET Framework version 1.1 or later.
• PACTware.
• HART
®
converter (USB, RS232...).
• The Device Type Manager for the device.
The software and installation instructions are given on the DVD-ROM supplied with the device.
You can also download the latest version of PACTware™ and the DTM from our internet site.
Refer also to the PACTware™ consortium site at http://www.pactware.com.
CAUTION!
If the manufacturer received information about the installation, the device will display readings
correctly. If not, refer to the quick setup procedures on page 57
.