KEPCO BHK-MG 200W (Full Rack) Series - Manual (Page 151)

BHK-MG (OPR) 022014
B-21/(B-22 Blank)
-221,”Settings Conflict” Execution error bit 4 Invalid password from syst:pass:cen command.
-222,“Data out of range” Execution error bit 4 Value exceeds power supply rating.
-223,”Data format error” Execution error bit 4 Multiple decimals in digit, Multiple E, etc.
-224,“Illegal parameter value” Execution error bit 4 For example, OUTP 2 instead of OUTP 1.
-226,”Lists not Same Length” Execution error bit 4 Dwell list does not match voltage or current list, or no
points found for voltage or current list.
-241,”Hardware missing” Execution error bit 4 Requesting device 2 status (INST:NSEL 2).
-282,”Illegal program name” Execution error bit 4 Executing prog:run without LIST:SEQ command.
-301,”Value bigger than limit” Device Error bit 3 (1) Requesting a time of 656 which is bigger than limit.
-311,”Memory error” Device Error bit 3 (1) Power-up NV RAM error.
-314,”Save/recall memory error” Device Error bit 3 (1) Using cell other than 1 - 41 for SAV and RCL.
-341,”Non Volatile Mem. CRC
error” Device Error bit 3 (1) Power supply constants may be corrupted; recalibration
may be necessary.
-350,Queue overflow Device Error bit 3 (1) More than 15 errors are in queue.
-410,”Query interrupted Query Error bit 2 New command sent before data from previous query read.
Previous query data lost.
-430,Query Deadlocked Query Error bit 2 Over 255 characters received in single input string.
(1) The Device error bit may be set when the status monitoring functions of the power supply detect an overvoltage/undervolt-
age condition.
TABLE B-4. ERROR MESSAGES (CONTINUED)
ERROR MESSAGE
ESR ERROR BIT SET
(SEE PAR. A.5)
EXPLANATION