KEPCO BHK-MG 200W (Full Rack) Series - Manual (Page 102)

3-58
BHK-MG (OPR) 022014
b. If load switch not used, press POWER ON/OFF key (once) on master unit, then slave
unit.
6. To disable power to the load:
c. If load switch used, open the switch.
d. If load switch not used, press POWER ON/OFF key: once on the master unit, then
once on the slave unit.
e. Alternative: Turn both units off by setting POWER switch to off (down) position, first on
master unit, then on slave unit.
FIGURE 3-21. SERIES MASTER-SLAVE (VOLTAGE MODE) CONFIGURATION