KEPCO BHK-MG 200W (Full Rack) Series - Manual (Page 149)

BHK-MG (OPR) 022014
B-19
B.84 SYSTem:KLOCk COMMAND
SYST:KLOC
Syntax: Short Form: SYST:KLOC Long Form: SYSTem:KLOCk
(0 or OFF, 1 or ON)
Description: Locks (ON or 1) or unlocks (OFF or 0) the keypad. With the keypad unlocked the power supply
enters Remote mode as soon as a command or query is received. Once in Remote mode (with key-
pad unlocked) the front panel keys are disabled with the exception of the LOCAL key, which is used to
return to Local mode.
After sending a SYST:KLOC ON (keypad lock) command, all front panel keys, including LOCAL, are
disabled. The power supply is now in the “local lockout” state and the LCD changes from
Loc to Rwl .
Local lockout can also be entered by sending the GPIB code (hex 11) to the power supply. The
power supply remains in “local lockout” until a SYST:KLOC OFF command is received. Related Com-
mands: SYST:KLOCK?. (See example, Figure B-7.)
B.85 SYSTem:KLOCk? QUERY
SYST:KLOC?
Syntax: Short Form: SYST:KLOC? Long Form: SYSTem:KLOCk?
Return Value: 0 or 1
Description: Identifies whether keypad is locked or unlocked. 0 = keypad unlocked, local operation possible by
pressing LOCAL key. 1 = keypad locked, LOCAL key disabled, only remote operation possible.
Related Commands: SYST:KLOCK. (See example, Figure B-7.)
FIGURE B-7. USING SYSTEM COMMANDS AND QUERIES
B.86 SYSTem:PASSword:CENable COMMAND
SYST:PASS:CEN
Syntax: Short Form: SYST:PASS:CEN Long Form: SYSTem:PASSword:CENable
Description: Sets the password enable state if the value matches the current password. This command allows
other commands such as all the calibration commands to operate.
B.87 SYSTem:PASSword:CDISable COMMAND
SYST:PASS:CDIS
Syntax: Short Form: SYST:PASS:CDIS Long Form: SYSTem:PASSword:CDISable
Description: Clears the password enable state if the value matches the current password.
B.88 SYSTem:PASSword:NEW COMMAND
SYST:PASS:NEW
Syntax: Short Form: SYST:PASS:NEW ,
Long Form: SYSTem:PASSword:NEW ,
Description: Establishes new password. The old (current) password is checked, then the replaced by the new
password. See PAR. 3.3.6.2 and Figure 3-2 for special programming considerations.
B.89 SYSTem:PASSword:STATe? QUERY
SYST:PASS:STAT?
Syntax: Short Form: SYST:PASS:STAT? Long Form: SYSTem:PASSword:STATe?
Return Value: 0 or 1
Description: Returns a 1 if the password state is enabled or a 0 if it is disabled.
SYST:VERS Returns 2003.0.
SYST:KLOC ON keypad locked, only remote control possible.
SYST:KLOC? Returns 1 indicating keypad locked.
SYST:KLOC OFF keypad unlocked, pressing LOCAL key allows Local mode
operation.
SYST:KLOC? Returns 0 indicating keypad unlocked.