Jenway 3540 User Manual
Page 78
Setting of these options is detailed in Section 3.37 and 3.38
The Model 3540 supports both hardware (CTS/RTS) flow control and software XON/XOFF
flow control.
Pressing the PRINT key outputs from the RS232 interface.
Sending an ASCII “D” to the 3540 causes a printout of the current displayed reading, plus
sample number.
Sending an ASCII “C” causes a printout of the last calibration parameters.
Sending an ASCII “P” causes a printout of the stored readings.
10.4 Keypad
emulation
Keypad remote control using RS232 interface:
7
- Instrument On / Standby / Escape
1
- Calibrate / Memory Clear
9 -
8
- Up Arrow
2
- Down Arrow
4
- Left Arrow
6
- Right Arrow
3 or 5 -
- Enter / Store
10.5 Printing
A 32-column serial printer (037 701) is available for use with the Model 3540.
Serial Cable Connection
Connect the serial cable supplied with the printer to the 9 way socket located on the rear
panel of the instrument.
To initiate a print out of data press the PRINT key.
When the first print is performed a header section will be printed showing:
Instrument name
Time and Date
Spacing for entry of Operator & User ID
Operator ID number